Glass splashback behind a kitchen worktop: what to settle first
Back-painted glass between the worktop and the wall units replaces tiles with one continuous, jointless surface. The main reason people choose it is cleaning. The main reason for complaints is that it was surveyed too early.

Why glass instead of tiles
A continuous surface has no joints, so there is nowhere for grease or mould to sit. It cleans in one pass. The second reason is usually the look: glass can be painted in practically any shade and the result reads more calmly than a tiled mosaic.
There are two drawbacks and it is only fair to name them. Glass is sensitive to survey accuracy, because it cannot be trimmed on site. And with toughened glass any later change means a new pane.
When it is surveyed
After the kitchen units are installed. Before that only a rough estimate for a price indication is possible. The real shape is determined by the fitted worktop, the position of the wall units and how the walls meet in the corner.
Kitchen walls are rarely square. For longer runs a template is therefore normal, rather than a measurement of two numbers.
Cut-outs for sockets and outlets
This is the most common source of trouble. Cut-outs for sockets, switches and outlets have to be surveyed and drawn before production. Toughened glass is not drilled afterwards and a change means a new pane.
The brief should give the position of every cut-out relative to two fixed points, typically the edge of the worktop and the side of a unit. If the electrician has not finished the outlets, the survey waits.
The section behind the hob
Behind the hob the temperature is higher and toughened glass is used. With a gas hob the distance from the flame and the height the splashback reaches are further considerations. The exact requirement differs by hob type and by the manufacturer's instructions, so have it confirmed by the firm supplying the splashback. Do not guess it from a catalogue.
How the colour works
The back of the glass is painted, so the colour is seen through the pane. That has a practical consequence: ordinary clear glass has a greenish cast that shifts the shade, most noticeably on whites and light pastels. If the shade matters, you need to know this in advance and either allow for the shift or choose low-iron glass, which is genuinely clear.
It is therefore better to look at a colour sample on glass than on paper.
Checklist before ordering
- the units are assembled and the worktop is fitted,
- the electrical outlets are finished and in their final positions,
- it is decided how far the splashback reaches, including behind the hob and up to what height,
- the shade is chosen, ideally on a glass sample,
- it is clear whether the glass will be bonded or mechanically fixed,
- it is agreed who removes the old tiling, if there is any.
Fitting and care
A splashback is normally bonded to a flat substrate with an adhesive intended for glass. An uneven wall has to be levelled, because a large pane will not take up the unevenness and could crack as it is pressed home. The joints at the worktop and the units are sealed with silicone.
Ordinary glass cleaner is enough for cleaning. Do not use wire wool or abrasive pastes, especially behind the hob, where baked-on grease tempts people to scrub hard.
There is more about glass infills and other surfaces on the page about shopfronts, door glazing and glass splashbacks.
Frequently asked questions
Can a glass splashback go over existing tiles?
Sometimes yes, if the tiles are sound and the surface is flat. The joints can print through into the gloss of the glass, and the thickness of the tiling pushes the glass further off the wall, which has to be resolved at the edges. A survey decides.
Can a splashback be split into several pieces?
Yes, and in longer kitchens it is usual. The joint is placed where it shows least, typically behind the hob or in a corner.
Send us the glass sizes
An e-mail address is enough. Tell us what broke or what you need made, and add the dimensions even if they are only approximate.
- Say whether the kitchen units are already installed.
- Mention whether the splashback should run behind the hob.
- Add a photo of the whole wall.